Fleece Performance PowerFlo Lift Pumps
The Fleece Performance PowerFlo Lift Pump is the only in-tank lift pump capable of supporting up to 800 Horsepower! The PowerFlo Lift Pump retains the factory water-in-fuel sensor, factory fuel heater, factory fuel lines, and installs in less than half the time of other high flow lift pumps. The active fill bucket eliminates the need for tank sumps, draw straws, additional air filtration, and the ¼ tank issues typically encountered when seeking a higher flow lift pump to meet your engine’s need.
- Direct Factory In-Tank Replacement
- Dual Gerotor Pumps
- In-Tank Pump for Faster Installation
- 2-3 Hours Estimated Install Time
- No Sump or Draw Straws Necessary
- Lifetime Manufacturer Warranty
The PowerFlo has two OEM quality gerotor pumps, increasing flow capacity and reliability over the factory pump. It is capable of supporting up to 800 hp and even works with dual CP3 pump configurations. And it is aftermarket capable. If you want the benefits of the in-tank pump but need to run your own fuel lines or aftermarket filters, the pump outlet and return is threaded to accept a -8 O-ring fitting (3/4”-16 thread).
You must be logged in
to write a review