Stage 2 Diesel Boost Coolers, similar to Stage 1 kits, progressively inject more or less water-methanol depending on manifold boost pressure. This Snow Performance Stage 2 kit has two dials to set the start and full points allowing you to custom program the delivery based on your engine’s needs. Progressively injecting according to boost pressure allows for the most power over the widest range of RPM’s.
These kits work on exactly the same principle as the Stage 1 kits, except that the controllers are heavier duty and can read up to 100psi of turbo boost. This is the typical starting point for a mildly modified modern 3/4 or 1 ton truck with an aftermarket exhaust, intake and chip or programmer. It is capable enough for trucks running large or compound turbo systems as well. These kits allow for great horsepower increases and EGT reductions – expect about 70hp and 250 degree F EGT drop.
- UHO (Ultra High Ouptut) Pump
- 3 Quart Reservoir
- 8 oz. Bottle of Boost Juice concentrate (mix 50/50 with water)
- Bulkhead Fitting
- Digital Variable Controller
- 2 Nozzles To Cover a Wide Range of Horsepower
- All Required Hardware & Comprehensive Instructions For Installation
Methanol has an ignition temperature 80 degrees hotter than diesel fuel. This means that methanol doesn’t pre-ignite your diesel fuel, and importantly doesn’t change timing. If you don’t have a source for methanol and you won’t be using Snow’s proprietary Boost Juice, we recommend you use blue windshield washer fluid, -20 degrees Fahrenheit, with no added glycol. This can be found across North America in most auto parts stores or even at Walmart.
If you would like to read more detailed information about water-methanol injection and it’s distinct benefits for turbo diesels Click Here
Manufacturer Contact Info:
1017-A East Highway 24
Woodland Park, CO 80863